![]() Choose Save settings and Restart hotspot for your changes to take effect. You may of course change this to allow legacy clients (older mobile devices, for example) by selecting TKIP+CCMP as the encryption type. AES uses the CCMP encryption protocol which is a stronger algorithm for message integrity and confidentiality.īy default, RaspAP's access point is configured with WPA2 and CCMP encryption. WPA2 is also backwards compatible with TKIP to allow interoperability with legacy devices. WPA2 is currently the most secure standard utilizing AES (Advanced Encryption Standard) and a pre-shared key for authentication. If for some reason a client is unable to obtain an IP address from your AP, consult this FAQ. ![]() These values may be changed in the DHCP options section of the DHCP server settings UI. Scan the QR code displayed on the Hotspot > Security tab and join the AP.īy default, clients are assigned IP addresses from the DHCP range 10.3.141.50 - 10.3.141.255.Select the SSID from the list of available networks on your device and enter the passphrase.When the AP is operational, you may connect clients to it by using one of two methods: This is a Linux systemd process that is responsible for starting up several network services in a specific order and timing. Save settings followed by Restart hotspot.Īt this point, a dialog will appear to indicate the progress of the RaspAP service. Your changes will be applied and made visible on the broadcasted AP by choosing Refer to this FAQ for more information.Įach of these settings may be changed on the Hotspot > Basic and Security tabs to any values you wish. ![]() It may be enabled by configuring a country that permits wireless operation on the 5GHz band. Note: The 802.11 AC 5GHz wireless mode option is disabled by default. After running the Quick installer or following the manual installation steps, RaspAP will start up a routed wireless access point (AP) with a default configuration.Īs part of this initial setup, the hostapd service broadcasts an AP with the following settings:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |